Isspro R8970 Manual de usuario descargar pdf

ISSPRO, INC. 2515 N.E. Riverside Way, Portland OR 97211

Telephone: (503) 288-4488  Toll Free: (800) 888-8065

FAX: (503) 249-2999

Form No. IS021 (7/8/03 Rev. C) Page 1 of 1

Installation Instructions for

R8970 Signal Generator

And

R8940 Feed-Thru Tach Sender

Mounting Instructions

a. Check R8970 Signal Generator to assure proper size drive tang is inserted fully into the

generator body. The drive tang is snapped into place, but is free to move allowing for

normal eccentricity.

b. Carefully insert the tip of the male drive tang into the female drive and screw the R8970

Signal Generator down finger tight. Tighten drive fitting securely; torque must not

exceed 15 lb-ft max. (Non-feed-thru and Feed-thru models)

Over-tightening can damage the unit and will void the warranty.

NOTE: The R8970 Signal Generator can be mounted in any position and works equally

well in either direction of rotation.

Electrical Connections

a. Make electrical connections to the R8970 Signal Generator, checking for clean, secure

connections.

b. Two conductor shielded cable is preferred to minimize electrical interference. The shield

may be grounded at the most convenient termination – one end only.

c. A twisted pair cable must be used if shielded cable is not available, to minimize electrical

interference.

For better seal, use heat shrink tubing over the spade connectors.

The use of single wire and common ground is not recommended.

An ohmmeter may be used to electrically check the R8970 Signal Generator. The

resistance will be between 200 ohms to 231 ohms.

Maintenance

No routine maintenance is required for the R8970 Signal Generator. If the R8970 Signal

Generator is installed in a harsh or severe environment, check terminations for clean and

secure connections. The snap-in drive tang may be easily replaced if worn.

NOTE: COMMON CAUSES OF FAILURE WHICH WILL VOID YOUR WARRANTY!

Do not over tighten!

Use of incorrect Drive Tip can damage these senders.

Do not over tighten! 1

Indice de contenidos

Pagina 1 - Do not over tighten!

ISSPRO, INC. 2515 N.E. Riverside Way, Portland OR 97211 Telephone: (503) 288-4488  Toll Free: (800) 888-8065 FAX: (503) 249-2999 Form No. IS021

Modelos relacionados R8940

Comentarios a estos manuales

Sin comentarios

Isspro R8970 Manual de usuario

Busca en linea o descarga Manual de usuario para Hardware Isspro R8970. ISSPRO R8970 User Manual Manual de usuario

Indice de contenidos

Modelos relacionados R8940

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Isspro R8970